Technical data - KAPPA 310
| Wire length, processing on both sides min. | 1 mm |
| Strip lengths, full stripping side 1 max. | 115 mm |
| Strip lengths, full stripping side 2 max. | 40 mm |
| Strip lengths, partial stripping/multiple stripping max. | 999.9 mm |
| Wire outer diameter max. | 10 mm |
| Flat cable width max. | 6 mm |
| Wire cross section min. | 0.05 mm² |
| Wire cross section max. | 6 mm² |
| Wire draw-in speed max. | 4 m/s |
| Drive system | Single rollers |
| Wire guide, side 1 | Swivel guide |
| Wire guide, side 2 | Fixed guide |
| Noise level | < 80 dB |
| Wire protection/ground | 2 x 5 × 20 mm 6.3 A |
| Nominal output (average) | 135 VA |
| Compressed-air connection | 5 – 8 bar |
| Operating pressure | 6 bar |
| Weight | 46 kg |
| Dimensions/length | 465 mm |
| Dimensions/width | 460 mm |
| Dimensions/height | 385 mm |
| Installation location | Level, stable and vibration-free support surface (e.g., Komax production table) |
| Size of production table (L x W) min | 630 x 690 mm |
| Load capacity of production table min. | 75 kg |
| Humidity, non-condensing | 90 % |
| Temperature operation | 10 – 40 °C |
| Processing outside the specifications | Processing outside the specifications upon request. In case of doubt, we will be happy to provide processing samples for your wires. |
| Hard, tough wires | In the case of extremely hard, tough wires, processing may not be possible even within the cross section range. In case of doubt, Komax will be happy to provide processing samples of your wires. |
